Repair Bootloop on Logo After Flashing on Samsung Galaxy J1 SM-J100H

Repair Bootloop on Logo After Flashing on Samsung Galaxy J1 SM-J100H
Overcoming Samsung J1 SM-J100H stuck on logo or what the people usually call it bootloop with flashing method. Samsung J1 hang on logo or this problem may happens when Samsung J1 camera flash is error when it switches on cannot access its main menu or homescreen. Problem like this are common because of the failure of the update process or it could be due to an error when installing application, it may because the applications we have installed does not match the Android version we have that makes our smartphone goes into bootloop.

We are not going to give Galaxy J1 review or Galaxy J1 price because we are going to focus to fix bootloop and flashing Samsung Galaxy J1 SM-J100H. Sometimes bootloop problems can also be overcome by doing Hard Reset in Recovery Mode, but if Hard Reset does not overcome bootloop, so there is another method to overcome it is by doing flashing.

In this article you will find Samsung Galaxy  J1 flash file and Samsung J1 flash file download easily. This article can also overcome Samsung j1 camera flash if it is error. Beside overcoming bootloop, this can also cope other problems such as application stops, mobile data doesn’t work, hangs, getting slow, and other issues.

After flash method is completed, Samsung Galaxy J1 SM-J100H will return to normal, or as at the time you purchase it.

Remember that, in this article we are going to telling you how to flash Samsung J100 with odin, but before doing flash on Samsung Galaxy J1 SM-J100H you must prepare some materials required, they are; Samsung USB, Driver for your Samsung J100, Odin tool, and Firmware with specific type of yoru Samsung Galaxy J1 SM-J100H. The third above had been provided by me and you can download it bellow freely. Pay attention please, and follow the instruction carefully:

  • Samsung USB Driver for Mobile Phones - Download
  • Odin v3.09 - Download
  • Firmware Samsung Galaxy J1 SM-J100H - Download
  • Steps to Flash Samsung Galaxy J1 SM-J100H
  • Extract Samsung USB Driver for Mobile Phones then install it on your PC/Laptop
  • Extract also Odin v3.09 and firmware Samsung Galaxy J1 SM-J100H that has been downloaded
  • Turn off Samsung Galaxy J100 (to ensure Samsung Galaxy J1 SM-J100H is truly off, please allow a few seconds).
  • Then go to Download menu by  holding Volume Down + Home + Power simultaneously until exit the last post warning.
  • Furthermore, press Volume Up to select Continue and it will automatically go to the navigation Download Samsung Galaxy J1 SM-J100H
  • Now connect Samsung Galaxy J1 to the PC/Laptop using USB Cable (use original USB Cable) then open Odin v3.09
  • Furthermore, check Auto Reboot F and Erase All, then make sure Samsung Galaxy J1 detected Odin with green color and there is the last post ID:COMin the Odin tool v3.09
  • Then click AP and looking for firmware of Samsung Galaxy J1 SM-J100H that has been extracted before, double click that firmware and it will automatic will be contained to Odin v3.09
  • Furthermore, click Start in the Odin v.309 software and automatic flashing process will automatically runs. Wait until it is finished, then if it is finished, Samsung Galaxy J1 will come out to last post PASS! As shown below
  • Flashing process takes less about 15 minutes.

Similarly, this article about fix bootloop on Samsung Galaxy J1 SM-J100H and we hope this article is useful for those who need this article to overcome bootloop problems.

Postingan terkait:

Belum ada tanggapan untuk "Repair Bootloop on Logo After Flashing on Samsung Galaxy J1 SM-J100H"

Post a Comment